Hi guys. So my Mini quit working last night. Spring does not appear to have collapsed and my digital volt meter says it's putting out 3.94v. I've put on several different attys that I know are good and none will fire. Any ideas?
Thanks
Thanks
Help! - Mini Failure
- Thread starter Nic_Fan
- Start date
- th_trl_thread_readers 0
- Status
Make sure the button is not in the off position. I know, too simple, but sometimes it happens.
Take out the battery and push the button. Does the contact point move down?
How is your battery fitting? You said the spring does not appear to have collapsed. Is the battery still reaching up to the firing pin?
There might be a problem in the connector. If that is the case then it needs to see Robert. You can always send him a PM for questions.
Take out the battery and push the button. Does the contact point move down?
How is your battery fitting? You said the spring does not appear to have collapsed. Is the battery still reaching up to the firing pin?
There might be a problem in the connector. If that is the case then it needs to see Robert. You can always send him a PM for questions.
Button is not locked. Yes the contact point moves down. Batt reaches the firing pin 'cause the device is putting out voltage. I better pm Robert I guess. Thanks for your feedback nerak.
Sounds like the gasket has been compressed and its not returning to its original position.You could try pushing up just a whisker from the bottom of your mod.Make sure you have a atomizer on the mod when you do this.
Problem solved. That was it Robert, thank you! I promise to be more careful to not over tighten my atty's. (he says head hanging). Thanks for the prompt attention. Talk about customer service. Wow. Really glad i ordered another mini just yesterday. Did not like not having a Reo for a half day even! You the MAN.
We always try to help here, but when you want the best, PM Robert! He knows everything!
Glad I could help adapters can kill mods as long as you have them set up properly its no different then using a standard atomizer 
- Status
