Help! My Silver Bullet is out of order!

[VenskeArtStudio]

I was hoping someone could help me because My SB's center connection pin got pushed in too far by a cartomizer and I don't know how to get it back up. Is there a way to get inside the head cap? Or can I try to use something like tweezers to fish it back up. Or am I just screwed?, Any help would save me, thanks.

Edit: Thanks to Chad and you guys I got it back up again

 

[keyzygirl]

Post in the Altsmokes sub forum and Im sure someone can help.Or you can put in a ticket on the Altsmokes site.

 

[dormouse]

Here is the Altsmoke forum

AltSmoke

And with any ecig - never screw anything in further than what's needed to contact electrically and work. That goes for cartos, attys, chargers.

 

[Renzuli]

You might also check and see if the center pin has a small screw slot . If it does , use a small screwdriver and turn the screw , counter clockwise , until it stops . Don't force it , just gently turn it out . And welcome to ECF

 

[VenskeArtStudio]

Here is the Altsmoke forum

AltSmoke

And with any ecig - never screw anything in further than what's needed to contact electrically and work. That goes for cartos, attys, chargers.

It's weird because I'm usually super .... about not over screwing my atty's etc into them. I think it's because I had a tank on it and couldn't tell how far down it was, the tank I have tends to spin or slide around on the carto. But thanks, I appreciate the help.

 

[VenskeArtStudio]

Thank you.