help on how to not get hot spots on smoketec rba

[danwelsh]

Ok, I modded my smoketec rba to be like a genesis, torched my ss mesh, and wrapped 32 awg a-1 wire, comes out at 1.7 on the ohm meter, problem is I can't get rid of hot spot on the positive post, pops every time, anyone got any tips on how to fix this problem, FYI I have an ra tank and don't have this problem, could it be the washers?

 

[danwelsh]

Think I figured the problem out after 10 coils and 5 hours and lots of patience, I had my coils wrapped way too tightly for one, re-oxidized my mesh, and made sure when the wire came off the coil to the posts it was to the inside or closest side to posts