HELP! RBA noob - what am I doing wrong?

[AlBaron]

Guys,
so last night I successfully build my first microcoil on a brand new Kayfun Lite +. Put it up on the MVP, and read a "1.3" YEAH!!!!
The vape was really good, but then the problems started. Every time I try to add juice from the top (unscrewing the the top cap and adding liquid directly into a tank - it's leaking from both airholes!!!!
Is this normal and should I only fill up the KF via the fill hole at the bottom of it (which means I have to carry the needle around with me), or is there another way to add juice without flooding my atty?

Please help!

Alex

 

[DoubleEwe]

Put your finger over the airhole when taking off the top part, keep it there until you screw it back on after filling.

I have never used the fill hole on my Kayfun3.1, always fill from the top.

 

[carsnguitars47]

what you need to do is fill from the top to desired height, then u thread the top cap on a few threads until just before it touches the o ring. then plug the air hole with ur finger and flip it upside down while u screw the top cap on the last couple threads. it sounds difficult but its not bad when u get the hang of it. good luck

 

[InTheShade]

Put your finger over the airhole when taking off the top part, keep it there until you screw it back on after filling.

I have never used the fill hole on my Kayfun3.1, always fill from the top.

This works, finger over the airhole, quick fill and you should be good.

Only other thing to check is make sure you are not pinching any of the O rings and they are going back snug and properly seated. I've had a couple of issues when screwing the top back on and I didn't seat the O ring that seals around the chimney correctly. That caused loss of vacuum and leaking.

 

[QuestionsGalore]

I've never used a kayfun so I could be wrong with what I'm gonna say, but on my nautilus I used to get that, but then I opened it up and tightened down the atomizer and it was fine. I did watch a video on the kayfun though and they said if that happens to blow into the air hole and then to vape on the largest air hole for a bit and be sure to draw very slowly. Not fast like a cigarette.

 

[Thejack1]

You could always just fill it through the proper fill port as well. My Kayfun is like having a second wife....