HELP! REfilling cartomizers

Status
Not open for further replies.
You MUST read the thread about the "spin" method. It is un-freakin-believable.

Put a ".... plug" and end cap on the battery end. Take out the rubber cap and white end cap. Put in 10-15 drops. Put on the rubber cap. Then put it in a battery bag, or some other bag where you're assured it's going to remain battery-end down, and spin. For about 30 seconds. The centrifugal force will force the liquid into the material. When you reopen it, the batting will be dry. Add more. Do it again. You can get 40 drops in a dry cartomizer. Less if it's not dry. The thread is in the V4L forum. Amazing thread and a great read. Other candidates for spinning: a glove, with all the fingers cut out except one. Check it out. Standard methods of refilling are over!!
 

beckah54

Dog Lover!
ECF Veteran
Verified Member
Jun 27, 2009
2,284
1,881
Ohio
Hi alsmom,
I just pop off the white cap and inner ring, drip the liquid along the side, not directly on the middle, until the fiber looks wet but not pooling on the top. Put it back together and vape. Make sure you put the rubber stopper and condom back on the battery connection end before you refill or it will leak out.
 

GrimmGreen

Reviewer / Blogger
ECF Veteran
Jan 30, 2009
1,190
51
48
Carson City, Nevada, United States
I watched the video, there is no way 15 or so drops is going into my cartomizer. after 5 drops its leaking out, and I am not getting the same hit as with a new cartomizer.. Help, I am running out of fresh ones. I have the Vapor King setup. I am new at this but have too many posts to go in the noob forum:confused:

if the juice is leaking out you are putting to much in and you still have enough juice in the cartomizer to vape. I personally drip in the battery side , 3 drops every 10 puffs right from the beginning. A few cartomizers have lasted well over 4 weeks using this technique.
 
Status
Not open for further replies.

Users who are viewing this thread