help with vision spinner 2 please

[narrdarr]

so i will be upgrading soon, but i need my vision spinner 2 to last me till then. so the problem is the fire button started to stick down today. i was wondering if there is a was to clean out behind the button or any other solutions. thanks

 

[wshanncap]

I'm not honestly sure how to get behind the button. One of my VS2s has done that since I bought it. I just learned through trial and error whick corner of the butto to push so it doesn't stick...as much.

 

[narrdarr]

yea sometime it doesn't stick, but when it does i just give it a whack on the table and it pops outs....lol... probably not the best idea.

 

[Fictitious Character]

I had this happen with one when I was using them. I ended up gripping the button on the side and wiggling it. This worked for a bit and then the button top popped off and it worked fine without that piece that has the V on it. I put the button cover back on until I lost it lol.

 

[Maiar]

Try this at your own risk. But when I worked with cell phones I could unstick buttons by putting some rubbing alcohol on a Q-tip and rubbing it around the edges of the button. Works on my xbox controllers too. And you could always stick a little needle or something in around the edges of the button and see if you can dislodge some gunk that may have built up there.
Good luck!