help with vortex 2.0

Status
Not open for further replies.

Cmlswa

Full Member
Sep 20, 2010
22
14
Chicago
i just received my vortex 2.0 with 3.5 ohm. i filled it asnd let it sit for 5 minutes to soak in and it wasnt making a connection when i connected it to my puresmoker V3. i had to screw it very very tightly and i finally got it to fire but it was burnt. after a few drags it stopped firing again. i tried pulling the conector on the bottom out to make it connect but still nothing. i tried to different carts with 2 different fluids(puresmoke 100% PG AND Innovapors menthol 100% VG) with the same results. PLEASE HELP!
 

washvap

Vaping Master
ECF Veteran
Apr 2, 2011
6,018
4,442
wa
Welcome to the ECF

You should definitely get up to 5 posts and then either make a thread in the general discussions thread or post in the ecigarette technical issues section of the forum:

Ecigarette Technical Issues

I'm sure you'll get the help you need there. Unfortunately don't have any experience with the vortex 2.0 at all. So, I personally can't help you out with that.
 

Hewoah

Full Member
Sep 16, 2011
8
1
VT
Hello! I'm brand new and this is my first post, but I've been reading through this forum for many months now-- great resource, so thanks to everyone who posts here and makes it such a great forum. Really makes the whole transition to vaping much easier to navigate.

So the entire 5 pack of the vortex 2.0's that I got do not seem to work at all. I got one to work briefly, but it just seems like they aren't making any connection to the battery or PT no matter what I try. I didn't get much help from gotvapes, other than to try turning the pin with a screwdriver (doesn't work). Any ideas?

(I realize from what washvap said above that I have to get up to 5 posts in order to post this in the technical issues section...so I'll save the rest of my explanation/question for my 6th post!)
 
Status
Not open for further replies.

Users who are viewing this thread