Help?

[Cakejameron]

Hey I have a kangertech subbox nano would I be able to put a indulgence mutation x v4 on it. I really wanna build coils and stuff

 

[Robert Cromwell]

The subox Nano will fire down to a .3 ohm coil so it should work ok. Not massive clouds or anything but ok. I would start with a .5 ohm coil build or a bit higher. And bue sure and use a GOOD 20 amp CDR 18650 in it.

Here is a nice coil builders tool to use to figure out your coil.
http://www.steam-engine.org/coil.asp?r=1.5&id=1.588&ll=4.762

I recommend watching vids on you tube about your atty and building coils.

 

[Cgates88]

You can put it on there and as long as the build is not too low then it will work. However it may look a little goofy since the Nano measures 18 mm I believe and the RDA measures 22mm so there will be some over hang