Reply to thread

Message

<blockquote data-quote="no|ah" data-source="post: 23654432" data-attributes="member: 416259">Thanks for the info, that&#039;s very helpful.You think it can accommodate a loose MTL draw or is it too tight? I&#039;m mostly about flavor, but taking a puff that&#039;s like pulling through a straw is no fun either.Sounds like that could be challenging to build in too, especially for a beginner. I&#039;ve been looking at old DNA mods that only do temp control with Ni200. (I think I like that sort of old school aesthetic even to a fault). Makes me wonder if I&#039;ll even be able to fit a <a href="http://www.steam-engine.org/coil?mat=ni200lin&amp;r=1.2&amp;awg=36&amp;id=5" target="_blank">~1ohm Ni200 coil suitable for MTL </a>in there. Any other MTL RTAs you think I should consider? I was originally thinking about the <a href="https://www.elementvape.com/vandy-vape-b3-mtl-rta" target="_blank">Vandy Vape B3</a> (or the B3 mini) before that Kayfun Lite Plus V2 Clone caught my eye.Thank you both, I appreciate it.</blockquote>

[QUOTE="no|ah, post: 23654432, member: 416259"] Thanks for the info, that's very helpful. You think it can accommodate a loose MTL draw or is it too tight? I'm mostly about flavor, but taking a puff that's like pulling through a straw is no fun either. Sounds like that could be challenging to build in too, especially for a beginner. I've been looking at old DNA mods that only do temp control with Ni200. (I think I like that sort of old school aesthetic even to a fault). Makes me wonder if I'll even be able to fit a [URL='http://www.steam-engine.org/coil?mat=ni200lin&r=1.2&awg=36&id=5']~1ohm Ni200 coil suitable for MTL [/URL]in there. Any other MTL RTAs you think I should consider? I was originally thinking about the [URL='https://www.elementvape.com/vandy-vape-b3-mtl-rta']Vandy Vape B3[/URL] (or the B3 mini) before that Kayfun Lite Plus V2 Clone caught my eye. Thank you both, I appreciate it. [/QUOTE]

Verification

Search

Search

Reply to thread