Hi

Status
Not open for further replies.

Mark1972

New Member
Jul 27, 2019
2
3
Welcome to the friendly bunch :)

I'm not familiar with that device. When you say ''knocking itself off'' what do you mean exactly?
It can be just sitting on the table and sometimes when I need to use it as I press the power nothing works and knocks itself off so I've got to knock it back on again and it works fine again
 

charlie1465

ECF Guru
ECF Veteran
Dec 30, 2014
10,789
72,826
Roquebrune sur Argens, Var, France
It can be just sitting on the table and sometimes when I need to use it as I press the power nothing works and knocks itself off so I've got to knock it back on again and it works fine again
Sounds like it's just got an auto shut off. So after a few minutes it shuts off and then you need to click 5 times to turn it on again....is that what's happening?
 

bombastinator

ECF Guru
ECF Veteran
Verified Member
Sep 12, 2010
11,784
24,660
MN USA
Sounds like it's just got an auto shut off. So after a few minutes it shuts off and then you need to click 5 times to turn it on again....is that what's happening?
This would fit with the common behavior of a person vaping less often after the initial changeover.

Welcome to the fourm btw :)
 

charlie1465

ECF Guru
ECF Veteran
Dec 30, 2014
10,789
72,826
Roquebrune sur Argens, Var, France
I glanced at the manual and there's no mention of a timed auto-shutoff.
It's faulty then. Didn't realise it was Smok because that makes it even more likely that there is an issue....

Be careful about using it and check that nothing inside is overheating. If it starts to overheat stop using it immediately.
 

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
13,625
12,100
Sunnyvale,CA,USA
I've been using the v fin box mod now for a few months it's great Aswel but I've started having problems with it over the last couple of days it's started knocking itself off for no reason I only use it between 24w to 28w iam using 18mg nicotine and the battery has power to over half full so what's causing the problem.
Welcome and glad you joined.
 
Status
Not open for further replies.

Users who are viewing this thread