I'm just learning electronics... seems to be my new addiction in more ways than one. lol
the cord from my passthrough only had two wires... easy enough.
the red being the positive or "supply" and the black is the negative "ground"
the diagram looks like this
-------------red wire-----------------------------------------usb
-----------cut black wire--------[switch]-------black wire---- usb
the red wire went straight to the original solder point in the center of the atomizer connector. no cutting.
the black wire needs to be cut. give yourself about the length of the tube or so and cut. strip the ends. tin them up.
solder the wire from the usb side to one leg of the switch.
the previously cut wire will be soldered in two places: the other leg of the switch, and the outside (already existing solder point) of the connector to your atomizer.
plug it in. push the switch. awesome vapor.
Hope that helps....
the cord from my passthrough only had two wires... easy enough.
the red being the positive or "supply" and the black is the negative "ground"
the diagram looks like this
-------------red wire-----------------------------------------usb
-----------cut black wire--------[switch]-------black wire---- usb
the red wire went straight to the original solder point in the center of the atomizer connector. no cutting.
the black wire needs to be cut. give yourself about the length of the tube or so and cut. strip the ends. tin them up.
solder the wire from the usb side to one leg of the switch.
the previously cut wire will be soldered in two places: the other leg of the switch, and the outside (already existing solder point) of the connector to your atomizer.
plug it in. push the switch. awesome vapor.
Hope that helps....
Last edited: