How to dip properly?

[stixs4321]

I seem to be getting great results when dripping but when I dip the draw gets harder and less vape.

I just want to know the proper way of doing this, everything can be done a right way and a wong way. I have the m401.

I would like to know how much of the bridge should go into the liquid(just the tip, the whole bridge...).

How long should one dip it into the liquid for? (1 second, 5 seconds, 15seconds...)

How many dips? (one dip then let it soak then dip again...)

Thank you

 

[DC2]

I seem to be getting great results when dripping but when I dip the draw gets harder and less vape.

I just want to know the proper way of doing this, everything can be done a right way and a wong way. I have the m401.

I would like to know how much of the bridge should go into the liquid(just the tip, the whole bridge...).

How long should one dip it into the liquid for? (1 second, 5 seconds, 15seconds...)

How many dips? (one dip then let it soak then dip again...)

Thank you

Hmmmm, that's a bit odd, because it sounds like flooded atomizers.

But back when I dipped the conventional wisdom was that it would only take up as much juice as it needed. So the advantage to dipping was that you didn't have to worry about putting in too many drops and flooding, like you might do when dripping.

However, I will say that you should just put the tip in the juice, not much further.
I used to keep it there until it wouldn't take any more.

 

[stixs4321]

Just the very tip of the atty? or the whole exposed part?

 

[DC2]

Just the very tip of the atty? or the whole exposed part?

The tip of the "bridge" that leads down to the atomizer.
The bridge is the part that looks like a bridge, and is covered with a metal mesh.

I wouldn't do it any more than halfway up the bridge.

 

[stixs4321]

Thank you, exactly the detailed response I was looking for.