how to get 1.2ohm+ with 24 gauge kanthal

[no_ you]

The only wire I have is 24 gauge kanthal and I am trying to build something for a friend in a small nimbus rda on a provari 2.5. I think it has a limit of 15 watts. I'd probably be using a 7/64 bit. Is this even possible to do?

 

[State O' Flux]

I'd probably be using a 7/64 bit. Is this even possible to do?

You can do it... but it'd barely heat up, and it'd take a good amount of time just to do that.

Look at the "Results" box in the right side of this link. Heat flux is a stone cold 55 mW/mm² and heat capacity is a bog slow 113.29 mJ/K.
Now look again at this link with 28 gauge... far more suitable for 1.2Ω @ 15w.