How to use Ithaka air control base with native Odysseus.

[Bubbertyboo]

Ok so i had a brain fart just before getting my Ithaka that i could use the 510 air control unit to use my ody in ggts mode.


But long story short the Ithaka has an extra long centre pin scuppering any chance of using the ody/ggts mode.


So here is how to do it using 2 bits.


1. Take an old 510 grommet and centre pin.





2. Pop the 2 parts together.





3. Place inside the 510 connection of the air control.







4. Attach ody into air control.





5. Attach to any 510 device and you have air control.





The only device i had in 510 is the chi you and that has air control already lol.


Also this makes for a good interchangeable unit if you have a few bits running the native ggts adaptor.

 

[moepmoep]

Brilliant.

Just used a center pin from an old Mega Carto and cut that to 4mm.

Wuahahahahaha, now i can use the Air Control on my Provari for my old atomizers

Thanks mate.

 

[anavidfan]

where did you get the grommet from? and the brass pin? Im sure most people get it, but Im not that saavy on things, I guess. And the air control , is that a GG part? or is that the base for the Ithaka. Id love to be able to have air control on my Saber Touch.

I just re-read your post, So that is Ithakas base.

 

[fright88]

where did you get the grommet from? and the brass pin? Im sure most people get it, but Im not that saavy on things, I guess. And the air control , is that a GG part? or is that the base for the Ithaka. Id love to be able to have air control on my Saber Touch.

I just re-read your post, So that is Ithakas base.

I have seen these gromets sold on e-bay but don't have any links. However a spares pack from some of the cheaper rba's should have a grommet in them. Or woese case scenario get a couple o-rings on it.

 

[Bubbertyboo]

They are from any generic 510 connection for diy use most online shops sell them for a couple of dollars its te middle part.

510 Battery Connector, Sealed

 

[jkim5708]

Wow..that ithaka looks gorgeous on that Chi!...cant waitnto get my hands on one of those....chi that is......3hours to go b4 ithaka shows up on front door....off to wick building .....

 

[RiverNut]

where did you get the grommet from? and the brass pin? Im sure most people get it, but Im not that saavy on things, I guess. And the air control , is that a GG part? or is that the base for the Ithaka. Id love to be able to have air control on my Saber Touch.

I just re-read your post, So that is Ithakas base.

Here you go ana. It won't increase atty's air potential but if you have some that are too airy, this will allow you to close it off a bit.
Tank Airflow Controller

 

[anavidfan]

Thank you all for the help, sounds good. Im gonna give it a try.