I NEED HELP... please

[Bodi]

You guys see that white circle rubber there right?!

Where do i put it please? I rinsed my vape then i put that white cirlce in the inhaling black thing then all my e-liquid juice leaked ALL OF IT! so please tell me where to put it!

I dont remember its place..

 

[Tonee N]

It goes on the bottom of the tank where it screws down.

Sent from my SM-G965U using Tapatalk

 

[gandymarsh]

I think it goes on the drip tip/mouthpiece under the flared out area. It seals the drip tip where it meets the tank.

 

[Shawn Hoefer]

The o-ring should, IIRC, sit in the groove just below the threads that attach the table to the body of the atomizer.

Honestly, those atomizers are about the worst. I highly recommend grabbing a Kanger Top Evod tank. Even an Aspire ETS. Both of those are easier to use and feature replaceable coil heads with organic cotton wicking.

Sent from my LG-H931 using Tapatalk

 

[suprtrkr]

 

[suprtrkr]

Probably in the groove by the arrow. There should be a shoulder machined on the inner side of the cap above the threads. But there are different manufacturers and the design can vary. If it won't go together like that, try putting it in the very bottom below the threads. And it may leak no matter what you do. Those things are designed to be disposable. They're not expensive, you may want a couple of spares. Or upgrade a bit to something like a Kanger Protank or Aerotank.

Edit:

Sorry for the double post. My machine decided to reboot when I had the top post open for an edit and when I came back it was (temporarily) gone.

 

[djsvapour]

I think it goes on the drip tip/mouthpiece under the flared out area. It seals the drip tip where it meets the tank.

Is the correct answer. Nice.

It is ALSO possibly missing another O-ring lower down as everyone is saying.

Either way, I am 99% sure the one in the picture is for the drip tip.

Maybe you lost another one? Maybe they are identical, but I doubt it.