Well I bought a BP a few days ago on the classys with the knowledge that the end to the wire to the cap had broken off once before and the previous owner had crimped on a new end. Well tonight while trying to change the connector cap the wire broke again.
I am probably going to send it in next week but I was wondering if there is an easy way to remove the VV unit? I ask because if I could pull it out a bit I might be able to crimp on another end.
Thans for any help.
I am probably going to send it in next week but I was wondering if there is an easy way to remove the VV unit? I ask because if I could pull it out a bit I might be able to crimp on another end.
Thans for any help.
I'm sending my bp in on monday to get fixed. That way it is done right. For future reference, if you ever take the top cap off, make sure you don't have a carto or atomizer screwed into the top. If there isn't a carto the entire center post that the wire is attached to will rotate freely. If you have a carto screwed in though it will not let the center post spin freely and you are going to snap the wire off from the connector.
