I was vaping on the Mantis from CigTech with the new ikenvape i06 atty. I was ready to charge the batery so I removed the battery while the atty was still attached to the Mantis. I then unscrewed the i06, blew it out, and instaled it on my Progigy v3.1 and nothing happen! I mean nothing. I switched atty's out just to make sure the mod was working and it was. Is it really dead? please help
I think I just killed my new i06 atty from Ikenvape!!
- Thread starter DrBrabham
- Start date
- th_trl_thread_readers 0
- Status
the prodigy has a different connector,,,, try bumping out the center pin just a bit on the i06, also try putting it back on your other mod to see if it works on that after it has some charge to it
On the bottom of the atty where the threads are the center metal piece is the post people refer t
n some mods the post gets slightly pushed in when screwed on,then when you put it on another mod it might be too short to make contact and fire.Just take your fingernail or small flathead screwdriver and run it under the center post pulling it down slightly and it should make contact and fire unless it is dead.Hope this helps.Later
n some mods the post gets slightly pushed in when screwed on,then when you put it on another mod it might be too short to make contact and fire.Just take your fingernail or small flathead screwdriver and run it under the center post pulling it down slightly and it should make contact and fire unless it is dead.Hope this helps.Later
Great advice, mwa, but the newb should also get a multimeter for these very times, its an invaluable tool for testing your attys for death and checking your pv's volts.........
- Status
Similar threads
