This is only partially true. Lately, one of my Iclear 16's and my CE5 won't screw into my MVP, but they will install into my ego batts. I have no trouble with the Protank nor with the MT3S heads. Could it be that my ego threads are stripping?
Iclear16 won't screw in my Itaste MVP 1
- Thread starter catlady60
- Start date
- th_trl_thread_readers 0
- Status
Seems like I've seen this before. Some itastes were made with 808d threading, some with 510 threading. Did you get it as a kit? Or did you buy the iClear16's separately?
http://www.e-cigarette-forum.com/forum/new-members-forum/512171-volt-itaste-mvp-2-confusion.html
Not sure if we're taking about the same thing.....
I got the Iclear16 as part of the kit. Plus, I picked up a few more separately. It seems as if the ones I got with the kit aren't fitting right; the others have no problem. I can tell my MVP is a version 1 because it's only VV. And it comes with 510-ego threads.
Last edited:
Hard to tell then. I'd contact the vendor, if I were having those problems... threading isn't one of china's pluses.
If you suspect your ego threads are going bad you could get a 510 to ego adapter and give it a shot.
NONE of my ego clearos will screw in my MVP1 anymore! It doesn't matter if they're Iclear 16's or CE5, they won't fit in the MVP anymore--even though they do screw in my cheap ego batts.
I don't have problems with my Protanks or my Unitank screwing in the MVP1. Could it be a problem with the MVP?
I don't have problems with my Protanks or my Unitank screwing in the MVP1. Could it be a problem with the MVP?
- Status
Similar threads
