Here's a simple fix 
Sometimes juice gets in between the gasket or even heat will soften it just a bit and allow the center post to slide a bit...sometimes it will happen during packing/delivery process. The common sympton is an atty that works on one device but not another. The center post is actually designed to slide to insure a proper connection but if you use one that pushes it in a bit and the next is recessed more....that poses a problem.
Notice the center post of threaded atty side may have slid less than flush with threaded outer ring. Use a paper clip or tweezer edge for a qwik fix. Heres how.
1. Take tweezer and slide GENTLY under ledge of center post and GENTLY shimmy up a little, then repeat on other side until even. If using a paperclip, insert into center hole at angle and GENTLY pry up until **JUST** above outer rim.
Your atty center post should look like this after. The one on the LEFT is the way it will look after you adjust it. The one on the RIGHT is a BEFORE pic.
This WILL work on other attys than the 510 but of course you will not have the outer rim there for measurement. A simple adjustment to ANY atty center post is sometimes needed, regardless of type and this will work on ALL models.
LEFT (AFTER) RIGHT (BEFORE)
Notice the center post is **just** above the rim. SORRY for crappy photos too, btw
Good Luck and HAPPY VAPING!
Sometimes juice gets in between the gasket or even heat will soften it just a bit and allow the center post to slide a bit...sometimes it will happen during packing/delivery process. The common sympton is an atty that works on one device but not another. The center post is actually designed to slide to insure a proper connection but if you use one that pushes it in a bit and the next is recessed more....that poses a problem.
Notice the center post of threaded atty side may have slid less than flush with threaded outer ring. Use a paper clip or tweezer edge for a qwik fix. Heres how.
1. Take tweezer and slide GENTLY under ledge of center post and GENTLY shimmy up a little, then repeat on other side until even. If using a paperclip, insert into center hole at angle and GENTLY pry up until **JUST** above outer rim.
Your atty center post should look like this after. The one on the LEFT is the way it will look after you adjust it. The one on the RIGHT is a BEFORE pic.
This WILL work on other attys than the 510 but of course you will not have the outer rim there for measurement. A simple adjustment to ANY atty center post is sometimes needed, regardless of type and this will work on ALL models.
LEFT (AFTER) RIGHT (BEFORE)
Notice the center post is **just** above the rim. SORRY for crappy photos too, btw
Good Luck and HAPPY VAPING!
