I'm an ultimate noob
- Thread starter VRabbit13
- Start date
- th_trl_thread_readers 0
- Status
Thanks for recommending.. but i do believe that is for a bigger thread to a 510.. buying that it will fix the problem of the tank but then it wouldnt fit my mod as its a 510... just odered my uwell crown..
BRO WHAT MOD WATTAGE, WHAT TANK WITH WHAT OHM RESISTANCE COIL YOU GOT, NEED TO KNOW THIS INFO TO BE ABLE TO ADVISE/HELP...
Heyya master p.. i got that sorted out earlier in the thread.. but currently i have a Tesla 160w TC mod and an joyelife tank.. which i found out only fits a joyelife starter mod.. just odered my uwell crown a few moments ago and hopefully it will do justice..
You seem to be getting the advice you need, so I'll just say hello and welcome you to the family.
Thanks mate appreciate it.. still lots of things for me to learn here..
You're in the right spot for that. Talk to us, and we'll do what we can to help.
@jseah has a good option. I believe it can work. You could then cover the unused eGo threading with a beauty ring. Here's another picture.
Actually it would work. The bottom is a 510 pin which would screw into your mod. The top has a 510 thread in the center and the eGo thread on the outside, so it would work with both 510 and eGo threaded atomizers. So your tank would screw into the 510 in the center of the adapter, and the outside ring of your tank would cover the additional height added by the adapter.
Some mods comes with the adapter, some don't. I believe you could probably pick one up at you local B&M for anywhere from $3 to $5. If you order it from Fasttech, I think they only charge $1 or $2 for it, although you would need to wait 2-3 weeks to receive it in the mail.
...that is one weird connector with a few problems... it's not the Tesla, it's the Atomizer. Technically, if you look up the specs of the tank, I'm sure it says it's a 510 threaded atomzier, and the Tesla is a 510 threaded battery... So... it... well.. should work. But, that atomizer looks like it was designed to fit flush with a particular mod, so it added a beauty collar on the bottom connector.. which makes it impossible to fit on anything but that mod.
Go ahead and order your new atomizer... But what to do with the old one....
First, I'd check the inner diameter of the ring. If it 22mm, then it should fit on a standard tube mod. If it can, then that atomizer is still useable with an adapter.. one suggestion would be THIS
The second problem, is the fact that the threads are painted like the above.. that might cause a voltage drop.
It also might help if you link to where you got it so I know more of what it is. There might be a different base you can buy for the atomizer that allows it to fit standard devices.
I hope this helps some.
I've tried the Uwell Crown tank in my IPV 2 Mini and I keep getting a burnt hit taste from my coils. I have to remove the tank and drip juice directly on the coil to get it to stop that taste. I went through all the coils in the package in less than a week.
Sent from my SCH-R530X using Tapatalk
Sent from my SCH-R530X using Tapatalk
Sounds like there is either a leak in your not allowing proper wicking of the coil or your air hope may be too big/not small enough to get a tighter draw....again in order to get the proper juice follow or "wicking" to the coil.
Sent from my XT1080 using Tapatalk
- Status
Similar threads
