Infinite Satin King Clone with an 18650 Battery and a Kick

[Zildjian]

I saw a review on the Satin King mod and purchased one.

In the review it stated that it comes with the Kick ring for use with an 18650 Battery.

Mine came with the ring, and I purchased two Sony VTC5 18650 batteries and a Kick from Elvov.

However it does not fit. I had to take the battery adjuster off from the firing pin, and have to leave about 1/8th inch gap between my Russian 91% and the top (not screwed in all the way) and I still cannot screw in the bottom switch in all the way (have an 1/8 gap here also) I split the difference between the top and bottom.

Am I missing something here? I have tried and tried and cannot get this to fit an 18650 battery with a kick. If you have a solution please share it with me.

 

[Zildjian]

Bumping, Anyone?

 

[joecil]

Are you using the 500 tube extension with the 18650 tubes? I don't have one but just looked at a picture of it and it shows 3 tubes which is kind of like my Nemesis except I also have a small beauty ring that takes some of the slack out of the button allowing for a good fit.

 

[Zildjian]

Yup I have all three pieces on it. I even took off the Battery rattle nut that adjusts on the 510 pin. It almost fits, just about a 1/4 inch too short. So I have split the dirrerence with a 1/8 inch gap under my atty, and 1/8 gap from being able to screw the switch in all the way.

 

[Susan~S]

Was the review on the vendors website? If so, email them for some advise/direction.