Hello once again and welcome back for today's review of a disposable device that uses 650mAh internal rechargeable battery and has the capability to have it's 2ml pod refilled. The innokin Endura S1 is a MTL device with a somewhat loose draw with claims of 7000 vapes until the coil gives up the ghost and dies. Lets check out some manufacturer information first so you will get a better understanding of how it operates prior to my review where I'll give you all my findings on it after using it for some time.
COLOR CHOICES
IN THE BOX
SPECICATIONS AND PARAMETERS
FEATURES
DEVICE BREAKDOWN
700 VAPES
MESH COIL FOR BETTER FLAVOR
FIRST IMPRESSIONS
Packaging on the Endura S1 is a bit different being that you need to pull off the 2 pieces of tape on each side of the bottom of the box then side the contents out, if you don't do it this way you will destroy the box trying to get the device out. Once pulled out you are greeted with the Endura S1 in a paper tray and the user manual.
As I always do with devices that have internal batteries is first charge them to full capacity for accurate testing, the USB-C charge port is on the bottom of the device with 2 holes above it that are airflow inlet holes, one of the holes is also the battery meter that uses only 2 colors for strength measurement ( GREEN - RED ). A plastic sticker is placed across both the USB-C charge port and 2 air feed holes to prevent operation of the device during shipping, once removed you can begin charging the device. When charging the device 1 air feed hole illuminates and flashes Red until it's fully charged at which point it turns to a solid Green color showing that it's fully charged.
COLOR CHOICES
IN THE BOX
- 1 x Innokin Endura S1 Pod Kit
- 1 x Quick Start Guide
SPECICATIONS AND PARAMETERS
| Battery Capacity | 650mAh |
|---|---|
| Battery Type | Integrated |
| Charging Type | USB Type-C |
| Coil Resistance | 1.1ohm |
| Coil Types | Mesh |
| Made In | China |
| Pod Coil Type | Mesh |
| Tank Capacity | 2ml |
| Weight | 33g |
| Height | 10cm (4.0") |
| Diameter | 1.9cm (0.7") |
FEATURES
- Battery: 650mAh (internal)
- Display: LED indicator
- Output: 3.6V / 13.5W constant
- Type C USB charging – 0.5A charge rate
- Pod capacity: 2ml
- Draw activated
- Fixed coil specification: 1.1ohm Kanthal Mesh
- Up to 7000 puffs / 20ml of e-liquid
- Side fill port
DEVICE BREAKDOWN
700 VAPES
MESH COIL FOR BETTER FLAVOR
FIRST IMPRESSIONS
Packaging on the Endura S1 is a bit different being that you need to pull off the 2 pieces of tape on each side of the bottom of the box then side the contents out, if you don't do it this way you will destroy the box trying to get the device out. Once pulled out you are greeted with the Endura S1 in a paper tray and the user manual.
As I always do with devices that have internal batteries is first charge them to full capacity for accurate testing, the USB-C charge port is on the bottom of the device with 2 holes above it that are airflow inlet holes, one of the holes is also the battery meter that uses only 2 colors for strength measurement ( GREEN - RED ). A plastic sticker is placed across both the USB-C charge port and 2 air feed holes to prevent operation of the device during shipping, once removed you can begin charging the device. When charging the device 1 air feed hole illuminates and flashes Red until it's fully charged at which point it turns to a solid Green color showing that it's fully charged.
