Innokin iSub G issue

Status
Not open for further replies.

NHXJer

Senior Member
ECF Veteran
Verified Member
Aug 28, 2013
192
560
United States
I've found that I get a lot of dry hits from my iSub especially using high VG juice.

I pulled apart a used coil and found that the cotton wicking is stuffed VERY tight through the coil - so much so that I think it's choking the juice flow.
Now when installing a new coil, I first take a set tweezers (fine point) and pull out a very small amount of cotton from the center of the wick - this loosens up the wicking a bit and I think allows better juice flow.
My iSub performs much more consistently doing this, imho.
 
Status
Not open for further replies.

Users who are viewing this thread