The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Innokin MVP 20watt 2600mah Battery Variable Watt/Volt Mod Now In-Stock at HDV

Discussion in 'High Desert Vapes' started by Brewtus, Mar 29, 2015.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Brewtus

    Brewtus Unregistered Supplier ECF Veteran

    Aug 16, 2010
    Albuquerque, NM
    Innokin MVP 20watt 2600mah Battery Variable Watt/Volt Mod

    [​IMG]

    [h=3]Product Description[/h] The MVP20W is the newest in the line of bestselling Innokin Technology iTaste MVP vaporizers and features a wider range of Variable Voltage and Wattage, advanced safety features, a long lasting 2600mAh battery, ‘Vape while you charge’ technology and the MVP20W e cigarette can also be used to charge your mobile phone and other electronic devices.

    The Primary Features of The MVP20W

    Variable Voltage:
    Voltage can be adjusted from 3.3 – 7.5 volts in .1 volt increments.

    Variable Wattage:
    Wattage can be adjusted from 6.0 – 20.0 Watts in .5 watts increments.

    Battery Level Indicator:
    The MVP20W e cigarette battery capacity is displayed via green, yellow and red LED.
    Green = Almost fully Charged. When the MVP20W fully recharged the LED light will power off.
    Yellow = Half Power.
    Red = Low Power. Charge the MVP20W.

    Large battery capacity:
    The MVP20W has a built-in 2600 mAh polymer Li-Ion rechargeable battery.

    ON/OFF battery switch:
    Press the power button three times in rapid succession to turn on the MVP20W. When the MVP20W is powered on Hold down the button to activate the atomizer and vape. When the MVP20W is not in use, press the button three times in succession to power off the MVP20W Advanced Personal Vaporizer. Always power off the MVP20W Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse.

    Ohms meter:
    Reads the resistance of your atomizer/cartomizer/clearomizer.

    Puff Counter:
    The integrated Puff counter will record the number of puffs you have taken. Either press “P “button or “U” button for 1 second to check the number of puffs. The Puff Counter will reset to 0 whenever the device is powered off.


    SAFETY:

    10 second Cutoff
    If the activation button is held for longer than 10 seconds the MVP20W Advanced Personal Vaporizer will stop firing until the button is released and pressed again.

    Low Voltage Warning
    The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the MVP20W Advanced Personal Vaporizer will power off automatically.

    Short Circuit/Atomizer Protection
    Short Circuit/Atomizer Protection protects the MVP20W Advanced Personal Vaporizer against shorted atomizers and will stop the unit from functioning in unsafe conditions.

    Over-Discharge Protection:
    The MVP20W Advanced Personal Vaporizer monitors the battery voltage and will automatically power off when the battery is discharged.

    ‘Vape while charging’ Technology
    The MVP20W is recharged with a Micro USB cable. When plugged into a power source the MVP20W can also be vaped and charged at the same time with Innokin Technology’s ‘Vape while you charge’ pass-through technology.
    Remembers last Voltage or Wattage setting
    When the MVP20W is turned off it will store the current voltage or wattage setting and it will retain the setting when the MVP20W is powered on.

    Built-in 3 digit display
    Digital display shows the Ohms meter, Voltage / Wattage setting and the number of Puffs taken since last time the battery was turned off.

    Portable power source for electronic products
    To charge your portable electronic device with the MVP20W - set the small pin switch on the bottom of the MVP20W to the ON position and connect a microUSB cable to the USB OUTPUT port (DC 5V, maximum output current 0.5A)To maximize the battery charge of your MVP20W e cigarette please ensure that the bottom switch is set to the Off position when you are not using the portable charger function.


    Technical Specifications:

    Operating Voltage: 3.3V-7.5 V
    Operating Wattage: 6.0W-.20W
    Standby current: 100uA max
    Maximum output Wattage: 20W
    Maximum output Current[FONT=宋]:[/FONT]6A
    Maximum output Voltage: 7.5V
    Clearomizer Resistance: 1.0 Ohm (minimum)
    Battery: Built-in 2600 mAh polymer Li-Ion rechargeable battery.
    Charging: Micro USB DC5V/1000mA
    OUTPUT port [FONT=宋]:[/FONT]DC5V /1000mA
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice