Introducing the NEW Kanger EVOD MT BCC 2.4ml 1.8ohm Bottom Coil Changeable

[Uncle Sam]

Wow, that thing looks really clean. May have to try one on my eGo T

 

[yiddleboge6]

I'm really loving the vape and the taste I get with the EVOD. So far the only negative for me is that it's hard to see your juice level if you're vaping a clear juice

 

[kellie]

I really love these more than my vivis. They are just perfect

 

[rdsok]

I really love these more than my vivis. They are just perfect

Now a-day's... you have to be more specific on which Vivi's you are talking about... Not only are there the Vision full and mini, but there are also the Smoktech and aClear's versions, all of which GV now carries once the Visions started getting hard to restock.

 

[kellie]

Now a-day's... you have to be more specific on which Vivi's you are talking about... Not only are there the Vision full and mini, but there are also the Smoktech and aClear's versions, all of which GV now carries once the Visions started getting hard to restock.

The vision mini. I can't keep them all straight.

 

[kellie]

Just ordered 3 more. Another purple, s stainless and a green. I actually found a ego t lime green battery

 

[nadja2]

noob question : these would fit on provari?

 

[Harplayr]

noob question : these would fit on provari?

These use an "ego" thread.
If you get an adaptor then you can use these on a provari

 

[tmoore]

noob question : these would fit on provari?

The adapters readily available at most vendors, nothing exotic. Google '510 to ego adapter' and you'll see lots of them.

 

[VapingTurtle]

The adapters readily available at most vendors GotVapes, nothing exotic. Google '510 to ego adapter' and you'll see lots of them.

eGo Adapter 510 - Outside Threaded for eGo Cone [gotvapes-EGO510adapter] - $4.25 : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more

(psssst... this is GotVapes sub-forum, not a general vaping sub-forum.)

 

[rdsok]

The adapters readily available at most vendors, nothing exotic. Google '510 to ego adapter' and you'll see lots of them.

In fact... here is GV's webpage for one eGo Adapter 510 - Outside Threaded for eGo Cone [gotvapes-EGO510adapter] - $4.25 : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more

 

[VapingTurtle]

In fact... here is GV's webpage for one eGo Adapter 510 - Outside Threaded for eGo Cone [gotvapes-EGO510adapter] - $4.25 : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more

I knew I saw that somewhere before.

 

[kellie]

I really like these a lot. I hope they get replacement coils for them

 

[Moses195]

I think I've had 4 heads go bad in the last 2 days. Anybody else? I swapped eVods to 3 different batteries to cross-check. Its the heads and not the Vamo. I almost thought my Vamo was screwing up and putting out WAY to much voltage but I don't think thats the case. I bought all 5 of the heads from a really nice vendor with good service, etc. I have 5 more on the way from another vendor because the 1st vendor was sold out. $1.50 ain't bad but 4 in 2 days?

Dana

 

[rdsok]

I think I've had 4 heads go bad in the last 2 days. Anybody else? I swapped eVods to 3 different batteries to cross-check. Its the heads and not the Vamo. I almost thought my Vamo was screwing up and putting out WAY to much voltage but I don't think thats the case. I bought all 5 of the heads from a really nice vendor with good service, etc. I have 5 more on the way from another vendor because the 1st vendor was sold out. $1.50 ain't bad but 4 in 2 days?

Dana

I've used mine with both a Vamo and a Kicked Bolt... no issues at all. I will say to make certain that you aren't over powering it, they don't need the power that say a Vivi Nova requires to get the same vape out of it... Badkola posted a recommended voltage chart somewhere ( in either the T3 or MT3 thread I believe ) that shows the recommended voltage ranges for each of the ohm heads that are available.

 

[Moses195]

I've used mine with both a Vamo and a Kicked Bolt... no issues at all. I will say to make certain that you aren't over powering it, they don't need the power that say a Vivi Nova requires to get the same vape out of it... Badkola posted a recommended voltage chart somewhere ( in either the T3 or MT3 thread I believe ) that shows the recommended voltage ranges for each of the ohm heads that are available.

No sir, that was the 1st thing I did, turn the voltage down to 3. I refer to that chart 20 times a day also. I think I got a bad batch cause the heads that came installed in my 4 eVod's seem ok except 1 that fried out the other day.
Thank You,
Dana

 

[tmoore]

I think I've had 4 heads go bad in the last 2 days. Anybody else? I swapped eVods to 3 different batteries to cross-check. Its the heads and not the Vamo. I almost thought my Vamo was screwing up and putting out WAY to much voltage but I don't think thats the case. I bought all 5 of the heads from a really nice vendor with good service, etc. I have 5 more on the way from another vendor because the 1st vendor was sold out. $1.50 ain't bad but 4 in 2 days?

Dana

I thought I had burned out one today, but found the head had unscrewed a little from the base. May want to double check that just in case.

 

[Moses195]

Thanks tmoore, I check that every time I fill one.


Dana

 

[Harplayr]

So far I'm still using my origional heads and all are working fine.

 

[AG51]

So far I'm still using my origional heads and all are working fine.

me too loves dese