My eleaf Istick 100w starts to go bad, where my car usb adapter evidently over charged it (say burned, like I see smoke coming from the usb plug in the device and quickly unplugged it). The Eleaf still works but can only charge my 18650's in the rack charger. I read the IPV reviews and order it from a vendor who's tagline is: "providers of box mods that work properly."
I have an Ehpro Big Buddha RBA on it and in every setting, TCR, Manual, SX Pure, Joule mode or Power mode, high or low wattage, high or low voltage.... the thing wont fire more than 2 seconds then I get the "Check Bat" message on the IPV screen. The IPV has almost zero in the box instructions and youtube aint much help....probably due to the infinite number of setting requirements depending on the tank, etc. Its way too regulated.
The Ehpro works fine in the Eleaf, shows my dual coil is subbed at 0.32 ohms and I get good cloud. But the IPV should be the better device....anyone have IPV 400 (typo in title .... no "n") settings resources or experience, I would use it.
I have an Ehpro Big Buddha RBA on it and in every setting, TCR, Manual, SX Pure, Joule mode or Power mode, high or low wattage, high or low voltage.... the thing wont fire more than 2 seconds then I get the "Check Bat" message on the IPV screen. The IPV has almost zero in the box instructions and youtube aint much help....probably due to the infinite number of setting requirements depending on the tank, etc. Its way too regulated.
The Ehpro works fine in the Eleaf, shows my dual coil is subbed at 0.32 ohms and I get good cloud. But the IPV should be the better device....anyone have IPV 400 (typo in title .... no "n") settings resources or experience, I would use it.
