IPV3 battery question

[HDMontana]

On some of the presell sites for the IPV3, which uses dual 18650"s, it says to use 30 amp batteries. I mainly pre-ordered this mod for battery life. Don't expect to go over 20 or 30 watts at this time. Would I still need 30 amp batteries or would 20 amp, which I already have, work OK? VTC 5's are non existent to buy at this time and I only own one. Thanks

 

[Baditude]

Not sure what processor the IPV3 uses, but Evolv (manufacturer of the DNA chips), recommends an IMR high drain battery with a minimum of 12 amps continuous discharge rating. Going by that, any of the 20 amp continuous batteries should work fine. http://www.evolvapor.com/datasheet/dna30.pdf

LG18650HE2 2500mAh 20 amp

Samsung INR18650-25R 2500mAh 20 amp

Efest (purple) 2500mAh *35 amp (a re-wrapped LG-HE2 cell)

Orbtronic 18650 SX22 2000mAh 22A

Orbtronic 18650 2500mAh 21A

Orbtronic 18650 SX30 2100mAh ​30A

 

[HDMontana]

Thanks Baditude. I was hoping you would see my question. You seem to be on top of your game with battery advice. I have two new lg batteries that you mentioned. Hoping to use them when the IPV3 finally shows up in vape mail. Thanks again.