IPV4S TC Issue. Help!

[smint777]

Hi,

Does anyone have this issue when building a Ni200 build on an IPV4S? I am not sure what is wrong with mine but it works fine with my friend's IPV4S.

If you notice, there's a symbol at my resistance reading and when i fire, my voltage will fluctuate as well.

It works fine on kanthal in power mode but in joules mode with a Ni200, this happens.

Help anyone?

 

[Wraith504]

Did you lock the resistance of the coil? Im hard pressed to believe you built a .5 nickle coil.

 

[smint777]

Did you lock the resistance of the coil? Im hard pressed to believe you built a .5 nickle coil.

What do you mean by locking the resistance to the coil? Is there anything that i'm missing? It is not a 0.5ohm build. Its actually a 0.21ohm. But my ipv4s doesnt read it. Instead it's showing that instead. It's not even a 0 before the decimal. It's like a // symbol.

 

[smint777]

I figured it out. Thanks for the set resistance tip. Feel like a total noob.

 

[Paul lamb]

Bump on this thread

I know how to lock resistance however my ipv4s is reading incorrectly

I have a .1 ohm build and the ipv is reading it as .4 what's going wrong? I am using ni200 28 it reads perfect in my. Evic VT