Is lower resistance than original parts a problem?

[Sludge Van Diesel]

I've got a couple of TECC ePipe II, which is now discontinued & I'm down to my last 2 attys.

I have found a supply that on first appearance are the same shape & size, but whereas the TECC ones are 2.4Ω the new ones are 1.8Ω.

Would using these cause any issues? I'm not going to be able to use the pipes anyway in a month, so I figure it might be worth a punt.

I've always used original parts for any device I've used (except when I was on M401 models), but my eRolls were available with normal & low resistance attys, so I'm wondering if these will work OK without knackering the pipes or going up in flames?

The batteries in both the TECC pipe & the one these are intended for are identical (18350, 3.7V, 700mAh)

Any advice appreciated. Thanks in advance.

 

[Sludge Van Diesel]

Can anyone shed any light on this? I'm down to my last atty & it's one of my favourite pipes.

 

[Izan]

Can anyone shed any light on this? I'm down to my last atty & it's one of my favourite pipes.

The pipe should handle the 1.8Ω just fine.
Unfortunately, you will need to try a few to see if they work for you. They may give a hotter or more harsh vape and will consume your batteries/juice more quickly.

Cheers
I

 

[Sludge Van Diesel]

Thanks