Is there an easier way?

[Debadoo]

I have an Orchid rta and the bottom tank section is murder to take off - requires me to put on a pair of rubber gloves. I don't imagine Noalux would be the best to use, so is there an alternative solution for atomizers which isn't toxic?

Does that screw on or fit down over an O ring? Maybe a thinner o ring, or if it screws on, don't tighten it so much, or use a tiny bit of e juice. Someone else will be along later that has used these, but just a thought for now since most folks are sleeping

 

[MamaTried]

It wouldn't be my first choice, would be hard to get it in there......... but if you really needed to, perhaps put the noalox into a sammich baggy, snip the tip and squeeze it into the bottle. But would depend on the size of the needle tip if it would come out ok without oozin out other places

i'm gettin kinda hot, Deb...

have you read this (unrelated) thread? http://www.e-cigarette-forum.com/forum/reos-mods/521257-just-did-bottle-mod.html

 

[Debadoo]

i'm gettin kinda hot, Deb...

have you read this (unrelated) thread? http://www.e-cigarette-forum.com/forum/reos-mods/521257-just-did-bottle-mod.html

rofl!! yeah I've seen the other one........but...but....I would have thought when I said "snip the tip" you woulda run screamin!!! lol

 

[Paramaniac413]

i'm gettin kinda hot, Deb...

have you read this (unrelated) thread? http://www.e-cigarette-forum.com/forum/reos-mods/521257-just-did-bottle-mod.html

Oh. Dear. Lord. And I'm only through the first page! lol

 

[Joules_Verne]

Saw a good trick for shaky hands mentioned a while back and mentally filed it away for possible future use -
Use something like a sling for a broken arm etc, pass it behind your neck and wrap the loose ends round your wrist and tie them off when the hand is at the correct level and under tension for coiling, wicking, bottle filling etc.
Pushing against the tension of the sling stops the tremors.
Wasn't able to verify the tremors bit but it steadied my hand nicely.
Hope this works for tremors !
Kudos to the OP.

 

[Waddle]

Does that screw on or fit down over an O ring? Maybe a thinner o ring, or if it screws on, don't tighten it so much, or use a tiny bit of e juice. Someone else will be along later that has used these, but just a thought for now since most folks are sleeping

Replaced the O ring, which was too fat, and the problem is solved. Thanks!

 

[Debadoo]

Replaced the O ring, which was too fat, and the problem is solved. Thanks!

Yay!! I said sumpthin that helped instead of just my usual gibberish!!! lol Glad it worked for ya! lol