Issue with my iTaste VV

[sistercreepy]

This morning I put on my Kanger Pro tank II on my VV and after a couple of toots on it I stopped getting vapor production. I assumed it was the coil so I replaced the head. Thought it was kind of strange that the coil would go out already because all of my equipment is less than a month old but I'm sure stranger things have happened.
After I replaced the head I put it back on the VV and it fired right up. I get in the car to go run errands and halfway down the freeway my Kanger quits firing again!! PISS! I don't have a spare with me! When I got home I put the Kanger on my Vamo and she fired right up. Any ideas why this might have happened? Is my VV taking a .... on me? The VV doesn't even recognize that there is a tank on it. When I do the ohm check it says "non".

 

[ghola1was]

I would gently pry up the "firing pin" at the top of the V3 with a small screwdriver or some such. You don't have to move it much, just work it upwards a little bit.

Should get you going again.

 

[Switched]

^^what he said^^ Yuz isn't making a positive connection

 

[sistercreepy]

Thanks for the tip!! It worked!!

 

[JWM2]

Sounds like the center pin on the bottom that makes the positive battery connection is grounding out. I've had this happen a few times and you can usually fix it by just twisting it slightly or moving it up and down if its spring loaded.