Issue with UD Bellus tank(ohms all over the place)

[donwuan]

Bought a UD Bellus tank and love the vape when working. Cleaned everything when I recieved the tank.

I normally vape around .6ohms with dual coil setup in everything I own. Main tanks are Big Dripper, Mutation x2 Aspire Atlantis v2 with rebuilt coils. Never had any issue when adding coils.

Ohms are jumping from .6-3.0 ohms. Had a day or so when it was consistent but if I refill the tank It started going crazy. Ive built my own coils with 24g kanthal, used prebuilt and tried the coils that came with tank. Normally vape between 25-35watts.

Im assuming its the tank that is the issue. Bought from 101vapes.

Any tips for getting this thing up and running.

 

[justdoeit]

Sounds like 1 of:
- post screws aren't tightened fully
- coil is touching the wall inside
- 510 connection between Mod and Bellus not connected well, adjust either's post

 

[roxynoodle]

Are you certain a coil isn't touching the inside of the chimney? Or a cut lead isn't? I've had a lead move during rewicking and touch another post as well.

If none of the above, I would pull the 510 pin and check the insulator and for metal shavings.

 

[MMW]

My guess is that the coils are hitting the inner chamber. When I tried putting dual 24g 2.8id in there that's what happened. Try pulling them closer to the center posts. It's pretty tight in there. I'm using 26g 2.5id at the moment.

 

[donwuan]

My guess is that the coils are hitting the inner chamber. When I tried putting dual 24g 2.8id in there that's what happened. Try pulling them closer to the center posts. It's pretty tight in there. I'm using 26g 2.5id at the moment.

Forgot to mention, this is without chamber on. It happen with or without chamber.

 

[donwuan]

101vapes said your SOL

 

[louiesquared]

I thought that I read somewhere that the positive post is press fit and a few people were having issues with it being loose. It was causing the same problems you are having. I cant find the thread that I saw it in though.

 

[mightymen]

I thought that I read somewhere that the positive post is press fit and a few people were having issues with it being loose. It was causing the same problems you are having. I cant find the thread that I saw it in though.

Good memory.

Yes one of my Bellus had that problem - If you can remove the posted by hand then yes most likely that is the problem.

To test it put the deck only with coil and wet wick law wattage is OK - fire it up and wiggle the post a little if you reproduce the problem then you found it, now fix it by giving the post pin two hits with small screw driver and hammer since I did this I had no problems made a snug fit.

* Don't do any hitting while it on the device - I'm sure everyone realize this but to be safe I said it anyway.