Issues with all kr808d-1 manuals! no vapor, but charged and lit LED

[Wifabif]

I'm totally baffled by this... I initially started with a starter kit from V2, absolutely loved it's vapor and ease of use and refilling, but found replacement batteries a bit pricey, so I got spares from V4L and myvaporstore. For months 2 spares worked great, and then one randomly went "out". It is fully charged (and won't charge further), but when I try to vape, I get no vapor. I push the button, the LED lights up, but nothing. I had this happen with 2 of them, got some replacements, as well as a charger from the site in case it was a non-compatibility issue, but after a week or so, the same issue would arise. I even busted out my first V2 manual, and when the LED lights up, it produces VERY VERY little vapor, if not any at all. I tried cleaning the threads, changing cartomizers (which I'm getting from V4L, which previously worked great) but I'm at a loss, with basically one functioning battery (with issues, check last thread....). I'd get another, but if it's something I'm doing, I'd rather not spend the money to have it not work.

Can I actually fix these manuals? Or shell out for more, despite the sad useless 4 that I have?

 

[Switched]

Try extending the centre post of either the battery or the carto, to ensure proper contact. It is either that or they received a bad batch IMO.

 

[Wifabif]

how do i do that? any metal to complete the connection? or is there some way to pull it?

what would have caused this to occur over a relatively short period of time, since they used to work?

thanks for the reply, btw

 

[Switched]

You use a hooked paper clip and gently wiggle the pos post back and forth while pulling slightly. Do this on cartos 1st, then batts. Always extend batt post on the disposable item - they rae usually the culprit.