Istick 30w and eleaf gs air

Status
Not open for further replies.

Burn3d

Senior Member
ECF Veteran
May 23, 2011
135
264
California
Hi everyone I just got my eleaf gs air in the mail today. It came with a 1.5 coil and when I attached it to my istick 30w it is showing 1.6 ohm? I checked the coil and it says 1.5 anyone had this happen?

I've been through 4 coils so far on the GS Air with iStick 30w and they all read 1.6. The fourth coil went from 1.6 to 1.7 after a bit of use which made me worried something was wrong. I switch to a new coil and MY FIFTH COIL ACTUALLY READS 1.5.

I don't trust the iStick after my last coil went from 1.6 to 1.7 so after setting my watts I switch to volts so i can easily tell if the resistance changed.

I try to push the coils longer than I suppose they should go. Generally I've read that a coil should be replaced after 30ml but I usually get 45ml out of them and push it to 60ml with less vapor production.
 
  • Like
Reactions: staceybritt13

staceybritt13

Super Member
ECF Veteran
Verified Member
I've been through 4 coils so far on the GS Air with iStick 30w and they all read 1.6. The fourth coil went from 1.6 to 1.7 after a bit of use which made me worried something was wrong. I switch to a new coil and MY FIFTH COIL ACTUALLY READS 1.5.

I don't trust the iStick after my last coil went from 1.6 to 1.7 so after setting my watts I switch to volts so i can easily tell if the resistance changed.

I try to push the coils longer than I suppose they should go. Generally I've read that a coil should be replaced after 30ml but I usually get 45ml out of them and push it to 60ml with less vapor production.
Hmm that's good to know.. mine appears fine and my new coils read the 1.5 like it should.
 

Burn3d

Senior Member
ECF Veteran
May 23, 2011
135
264
California
All my coils are from the same 5 pack and the original in the GS Air. The last coil going to 1.7 has me a little worried. I hope my iStick is not messing up.

What I also did was before I put in the new coil that reads 1.5ohm I put in an old coil that always read 1.6ohm but it also read 1.7ohm. After fiddling with the old coil for a bit it finally read 1.6ohm.
 
Status
Not open for further replies.

Users who are viewing this thread