itaste MVP issue

Status
Not open for further replies.

thomas.egnoto

Full Member
Jun 21, 2013
53
30
36
Syracuse, NY
Hey all, so I got an MVP from fasttech a couple weeks ago, and I'm having a strange issue with a drip atty I got from a mall kiosk. I was dry burning it, and after a couple fires, it wouldn't fire anymore. When I press the button, instead of the green light fading on and off, it goes straight to green and stays that way for a couple seconds after I let go. If I take the atty off, fire it, and screw it on while I'm holding the button down, it works fine, but when I let go and try to fire it again, the same thing happens. The atty works fine on my ego twist, and this doesn't happen when I use the MVP with any other tanks or cartos. Any thoughts on what the problem could be? I tried turning the MVP off and on a couple times, no luck.
 

Penn

Ultra Member
ECF Veteran
May 19, 2013
1,367
1,435
In the wilderness
If this is a V2 let us know what the ohm reading is before the first fire and after. If not I don't know what to tell you. I had this problem with an ego and my MT3 first time I rebuilt the head on it but I just rebuilt and it went away. My guess is there is just something wrong with the wrap and your MVP is setting it off. What volts/watts are you setting it to?

I have only had one issue with my MVP. I only use my egos when I am charging it. I could use the passthrough function but I don't want the egos to be too neglected.
 
Status
Not open for further replies.

Users who are viewing this thread