itaste vv3.0 issues (please help!)

Status
Not open for further replies.
Well here goes my first post.I have been having issues with my itaste vv3.0 which i purchased on halloween this year. The ohm reader is jumping all over the place. I am using a VapeOnly ET-S tank with 2.2ohm dual coil. My itaste is reading anywhere from 1.9 - 9.5ohms. This is also happening with my KangerTech Evod single coil (not sure of the coil ohm resistance). It also sometimes reads non with my tank on the battery and still vapes and the 10 second cutoff is randomly engaging early (I notice this most when I am using it during the pass through while charging). This is my second itaste because my first one after about 6 months was no longer holding the battery charge and really liked it and had no issues until the battery life went to nil. Anyone else ever have these issues? Or possible tips to resolve issue?

Thanks!!
 

VapourStore

Moved On
Nov 26, 2014
0
2
Sheffield, Worksop
  • Deleted by Robino1
  • Reason: Unregistered Supplier

Cool-breeze

Super Member
ECF Veteran
Nov 24, 2013
765
797
Upstate sc
I didn't know there was a bad batch of V3, so I guess that could be the issue. Other possibilities that come to mind is make sure the atomizer is screwed in to the tank snug, the tank is snug on the V3, or perhaps the 510 pin is pushed down into the V3. That can happen if you over tighten the tank or use a tank with a longer post. If you still have your old V3 it could be useful for checking your atomizer to help eliminate possibilities.
 
Unfortunately I did try to exchange my itaste about 1 week ago but my vape shop only has a 2 week return policy. They suggested getting new coils and that should solve the problem. I was guilty of over tightening on my old itaste until my vape shop told me otherwise just prior to buying my replacement. So with my new one I have been super aware to make sure I am not over tightening and the atomizer is nice and snug. I tried connecting my old itaste VV to both of my tanks and it is working great. I only wish my old itaste held the battery charge (i'm getting maybe 50 drags per full charge which is why I purchased the replacement) I am currently emailing Innokin through their support page and have sent a video showing the ohm resistance reader jumping all over the place. Thanks for the heads up on the bad batch of VV's and that this sounds most likely as to what I may be encountering.
 
Status
Not open for further replies.

Users who are viewing this thread