Ithaka, no atty detected

[littlewierdo]

So, I wrapped my first coil, 4 wraps around two wicks, then put the wicks so that they went from corner to corner (not parallel).

One end of the wire that was on the metal channels I wrapped around the nut and tightened the nut, the other side of the wire I wrapped around the tiny O ring.

I attached the two bottom pieces (the air flow control ring and whatever the other piece is called) and left the tank unattached for the moment.

I attached to three different PVs and none of them even see an Atty connected.

What I noticed is that the brass center isnt far enough down to make contact with the PV but I cant screw the air flow control ring any further in order to make the brass pin make contact...

Oh, and speaking of which, is there supposed to be a 'pin' in the center of the brass contact? Because there isnt one and every other rebuildable I have has a pointy rod that is spring loaded that is the thing that actually makes contact with the PV...

I hope all this makes sense, I really dont know what Im doing wrong...

 

[Jojobo]

did you unscrew the brass part of the pin to extend it further? That brass part of the ithaka pin screws up and down depending on how far out you need it.

 

[Ariel_MX]

And you can unscrew that brass pin long enough, it will adjust automatically to the proper lengh when screwing Ithaka into the mod.

 

[littlewierdo]

And you can unscrew that brass pin long enough, it will adjust automatically to the proper lengh when screwing Ithaka into the mod.

Yay! It works!

Thanks!

Now, to see what this little bugger vapes like .