Ithaka Tweak No Bubbles .6 ohms Duals

[imeothanasis]

it seems we are a great team bish! Have a nice day buddy

Imeo i love your way and I agree with you hundred percent. Thats why i so busy making coils for people. LOL I like what you did very very much. I praise you for it. I just finish making video of nut replacement and my thoughts of it.

 

[blackwater]

Can we get a link to your video Imeo?

Thanks!

 

[blackwater]

Does anyone have a link to a vid for using 2 premades on one wick?

 

[Ariel_MX]

Does anyone have a link to a vid for using 2 premades on one wick?

I think there is not a one wick option on Ithaka, how I did it was similar to the simplest configuration "single coil and two wicks" (the coil is around both wicks), but instead using a single coil I used two coils around the two wicks.

Like Imeo did on his video, but instead using a dual coil per wick (four coils in total) and X style, I only used a pair of coils and two wicks.

After the setup, I just tweaked a little the coils to have them evenly spaced.

 

[blackwater]

I think there is not a one wick option on Ithaka, how I did it was similar to the simplest configuration "single coil and two wicks" (the coil is around both wicks), but instead using a single coil I used two coils around the two wicks.

Like Imeo did on his video, but instead using a dual coil per wick (four coils in total) and X style, I only used a pair of coils and two wicks.

After the setup, I just tweaked a little the coils to have them evenly spaced.

Sorry Ariel. Yes,you are correct. I'm looking for video he did with two wires around 2 wicks. Not The dual x config.
The one he talks about in this thread.

 

[Kataphraktos]

I got my 36g Kanthal A-1 today, and built my first dual x setup on 1mm Ekowool. Alas, I hit 1.6 ohms, instead of the 1.4 I wanted, but it is still a really really nice vape. I included a tiny strip of 1mm Ekowool on top of the upper coil, as shown here.

I also figured out how I kept flooding the bloody thing. I wasn't tightening the assembly into the base tight enough, and I was tightening the juice control too tight, so when I tried to open the juice control after completing the setup, the juice control would stay put and the assembly would start unscrewing. Lord, what an idiot I am sometimes.