Sorry in advance if this posting isn't in the correct location this is the only forum thread I can post in. I need help badly! My ipv mini and lemo was working just fine, I went to hit the fire botton today it said "check battery" so I hit the fire button again and it start acting funny the ohms are jumping up and down every time I fire. Volts are going crazy. Please help!
Ivp mini 30w with lemo tank ohm problem.
- Thread starter dvolion11
- Start date
- th_trl_thread_readers 0
- Status
Check the bottom 510 pin on the Lemo. Make sure it's screwed all the way in.
The take the bottom portion of the Lemo off, and take a look at the center post the airflow ring sits on. Make sure that's tight as well.
I notice my ohms jumping a little when things are getting a bit loose.
The take the bottom portion of the Lemo off, and take a look at the center post the airflow ring sits on. Make sure that's tight as well.
I notice my ohms jumping a little when things are getting a bit loose.
This...usually just tighten your posts or your center pin...happens to everybody at least once
- Status
Similar threads
