hi guys just bought a joytech ego aio yesterday after work which was like around five pm. Primed the coil drop five drops in the middle it's a tiny little coil and I vaped like three two ml tanks and was getting burnt hits already!! Any tips or advice? I flooded the second coil took some non powered vaps off of it lets see what happens!
joytech ego aio How long do coils last?
- Thread starter rcalvy1
- Start date
- th_trl_thread_readers 0
- Status
Had the same problem myself today when I got my AIO. I ordered some 1.0 ohm coils and will try again with those. The two that came with my kit burnt after just a little use.
I toasted my first 0.6 pretty fast as well.
I'm using the pre-built RBA head at the moment and have some 1.5 Claptons to try next, but some are still going to town on their first coil... two weeks later.
I think I just got too enthusiastic myself, but I'm still cautious with this second try.
I'm using the pre-built RBA head at the moment and have some 1.5 Claptons to try next, but some are still going to town on their first coil... two weeks later.
I think I just got too enthusiastic myself, but I'm still cautious with this second try.
Been using the 1.5 coil all day without a problem.
All the ones that are made for the Cubis will work with the AIO, but NOT the Ti, or Ni... those are for temperature control devices only.
No problems here (I have 2, one of them I've had for 2 weeks) as the above mentioned, but I do have had dry hits because I thought there still was enough juice in the tank where there apparently wasn't. The funky light can make it look like there still is for 5-8 puffs, but no.
I used the .6 coil (and 3mg juice) with my first AIO because it came with that, and today, as my new AIO arrived, I also got 1.0 coils from Fasttech. So I tried to put one of those in the new AIO with a 16mg juice and phew, I almost get dizzy because of the nicotine! The vapour is still great, still makes fine clouds, not much (of any) difference between the two setups.
What I have observed, however, is that my first AIO with the .6 coils tends to get pretty warm when I chain vape. The new one with the 1.0 coils doesn't (yet?).
I used the .6 coil (and 3mg juice) with my first AIO because it came with that, and today, as my new AIO arrived, I also got 1.0 coils from Fasttech. So I tried to put one of those in the new AIO with a 16mg juice and phew, I almost get dizzy because of the nicotine! The vapour is still great, still makes fine clouds, not much (of any) difference between the two setups.
What I have observed, however, is that my first AIO with the .6 coils tends to get pretty warm when I chain vape. The new one with the 1.0 coils doesn't (yet?).
- Status
Similar threads
