• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Juice leaking through air vent/ Aromatic mods

Status
Not open for further replies.

Minzy

Super Member
ECF Veteran
Verified Member
Nov 29, 2014
347
180
Syonando
I mean Kayfun Lite, sorry work stress LOL


Dead man Walking.

well, leaking usually happens with improper wicking. you could try raising the coil higher off the air hole, and make sure absolutely no wicking material is touching, or even close to the air hole. Also, try not to use too much cotton. As some say, 'less, is more". it may help. :D however, i don't think theres a way to have absolutely 0 leakage with a KF. i could be wrong tho. :/
 
Last edited:

Jun Andaakabaa

Senior Member
ECF Veteran
Verified Member
Dec 1, 2014
231
132
Little Red Dot
well, leaking usually happens with improper wicking. you could try raising the coil higher off the air hole, and make sure absolutely no wicking material is touching, or even close to the air hole. it may help. :D however, i don't think theres a way to have absolutely 0 leakage with a KF. i could be wrong tho. :/

mine was good:p
 

Leech

Full Member
Jan 12, 2012
63
161
Man Cave
Try keeping your mod upright.
I find that a flash light holder works very well to keep it in the upright position in the bag.

The KFL+ usually doesn't leak when on it's side, so long both channels have juice covering them. Once juice falls below a certain level, and either one of the channels are exposed when it's laid on it's side, it will allow the liquid to slosh into the chamber and that might cause a leak.
 
Status
Not open for further replies.

Users who are viewing this thread