Just joined the World of Vaping!

Status
Not open for further replies.

bananasg

Full Member
Nov 28, 2014
58
22
I wish I am there
Hi fellow Vapers!

Just dropping in to say HARLOooow as I am new to ECF! Learning a lot of things as I browse through the forum threads!

Overview till date 15th Dec 2014:
Quit smoking: 22 Nov 2014 9am
Not smoked: 350
Money saved: S$192.50

I will continue to strive on, Cheers!
Arsenal:
Hana Mod 50W
Kayfun Lite v2 RBA (single vertical coil - 1.2 to 1.5 ohms setup)
Plume Veil RDA (dual coils - 0.6 to 1 ohms setup)
 

bananasg

Full Member
Nov 28, 2014
58
22
I wish I am there
Thanks mate!

I am still in the midst of exploring the coil setup for flavor....new to it so fiddling around...noticed I don't dare to up the wattage coz am afraid of the burn taste...

Any advice will be much appreciated!


Congrats! That one hella capable and fun setup to start out with, you're in for a lot of fun.

*gives the horns*
 

bananasg

Full Member
Nov 28, 2014
58
22
I wish I am there
Thanks & will do that!

I am trying to figure out the values to input into steam engine mod range.

Can some advise if the voltage and current is output or input limit for this mod range link.



Just increase your wattage slowly and when it starts to taste a little off drop back down to a slightly lower wattage. As long as you don't increase it in big jumps you shouldn't get a really bad burnt taste.
 
Status
Not open for further replies.

Users who are viewing this thread