Just recieved my first dripping atty

[hesta]

As in the title, I just got my first dripping atty, and having a play with it now, just want to know any tips to help avoid popping the coil, as I have read its easy to do for a newby (and only bought one, as just playing with different vaping methods at the min), also how long should the few drops last? I'm getting a dry hit after a few draws, and topping up again lol, amazed by the amount of vapour! But, the flavour seems no different from my nova - does it improve once its 'broken in' a bit?

Its a 306 bridged atty btw

Thanks in advance!

 

[The Ocelot]

Hi Hesta! I'm going to send you a PM with some tips (I haven't had my coffee yet, so I'm not going to type it out here )

 

[ZooKansas]

You made good choice in getting a 306. Congrats on your first atty. I remember how amazed I was after trying dripping for the first time. I would suggest no more than 3-4 drops at at time to avoid flooding the atty. You should get at least 5 good puffs before topping off. As for popping the coil, I would not vape it high resistance. IE...if the atty is a 2.0ohm, don't vape it over 4 ohms for awhile. This is a fantastic drip-tip for the 306. Cannon | Drip Tips | E- | Cigs | Cigarettes | Cisco 306 | Cherry Vape I chose to get the white one because you can kinda see through it a bit. Flavor can improve after a few days of breaking in. Hopefully, it last you a good month or so before it dies.

 

[hesta]

Thanks guys

No choice in ohms at the moment, its a low resistance atty and I only have an ego until my vamo arrives in the post, so kinda stuck with what I've got lol, got to take it steady, just vaped away 4 flavours in a row, now my head is spinning!

Got a cool see-through yellow marbled tip for it as well, but it doesnt sit flush to the bottom, dont want to force it too hard! I'll put up a pic in a min, is this normal? It's 'juice tight' so isn't leaking

 

[The Ocelot]

DON'T PUSH DOWN TOO HARD! Sorry for the yelling, but I pushed my first Cannon down onto my 306 and even though it looks perfectly normal there is a minute indentation in the plastic. I have to drip with a paper towel handy since it leaks down the side.

 

[hesta]

Yeah, that was my worry, so I havent pushed it any more than in the pic, sits tight and snug, but not too much force required to get it off

Thanks for the PM as well