Just recieved my Kanger Mini Protank 2!!

[LEDBETTER122]

Despite some of the negative reviews on the Kanger Mini Protank, I went ahead and ordered me once (since it only put me in the hole $14), and AM I GLAD I DID. I figured when in came in "Knowing my luck" I was going to get the factory default.

Boy was I wrong, This is probably the best glassomizer I have used, I'm the type of person who likes a sleek & slim design while also producing massive clouds of vapor. The Kanger mini has done it for me, I run it at 4.0-4.2v with a 2.2Ohm coil and it produces great cloud of vapor.

So far way worth the money!

Pros
Produces nice vapor
Slim & Sleek design
Reasonably Priced
Everything is completely replaceable

Cons
Drip tip does not screw on (Afraid it will come off one day, and become lost)

 

[1buda]

All that holds the drip tip is a o ring. Mine does the same too... Maybe buy a few spares?

 

[wjosephsimmons]

I've been using the PT II and the PT II Mini exclusively since November and I'm especially pleased with the Mini. The drip tips are still quite tight-fitting, despite a lot of on-and-off use. I can't see them wearing out. Supposedly the drip tip o-ring is different from the spares in the box (but I'm not prepared to take it off the drip tip and risk damaging it to find out). What I have found is that I lost the rubber o-ring that seals the base of the Mini (where the coil screws in) without knowing it, and while it still worked, the draw was not right until I replaced it with one of the spares from the box. Huge difference! It must have come off when I was washing it or soaking it in PGA. They also are used to replace the seals in the top and bottom of the tank assembly. You can get extra o-rings for 34 cents each from The Digital Cig, LLC. I already stocked up on both sizes.



For a clear picture, click on this second photo and see, at the bottom right corner, the two bottom illustrations)