Kamry Telescopic Storm (KTS) Firing button

[Sealander]

Hi! Just new on the site. i have a Kamry Telescopic Storm (KTS) mod. I noticed at times when i press the firing button it doesn't make full contact with the terminal on the end cap to which the spring is attached. I have to press a bit harder to make it full contact. I recently browsed a site selling the KTS with the description that the firing button "play" can be adjusted. I don't have a manual so I don't know how to adjust it. Maybe some of you can show me how. Just new to full mech mods. A provari is my daily use PV. TIA!

 

[4matic]

If you take the bottom cap out and look through the tube you will see a little nut that you can tighten/loosen so that the button is able to reach that negative post.

 

[Sealander]

Thanks. Will check on that.

 

[Sealander]

Now that I've adjusted that little nut...sometimes it would just unscrew by itself. It has happened 3x good thing the firing pin has not spring out. Any remedy for this? I thought of putting a wee amount of loctite on it but I thought what if I have to dismantle it.