Kanger 1.5 Ohm Evod, PT 1/2, etc. Coil Heads available?

[dodari]

Somewhere I thought I saw where Kanger was going to make 1.5 Ohm Coil Heads available for the Evod, ProTank 1/2 and the others that it will fit.

Does anyone know and have tried them? Do they Ohm out at pretty close to !.5 Ohms? The 1.8 Ohm ones I've gotten are all over the place, usually higher than advertised, sometimes .7 Ohms higher. Crappy QC.

 

[SupplyDaddy]

Kanger makes the following coils:
1.5 Ohms 1.8 Ohms 2.2 Ohms 2.5 Ohms each for the-
Kanger Protank 1&2, Mini Protank 1&2 heating coil
Kanger E-vod heating coil
Kanger MT3S / T3S heating coil

(All three are still shown on their wholesale pages, but expect to see the evod coils disappear according to the next statement)

They state the following:
Bottom coil for Kanger Protank & mini Protank are compatiable with Kanger E-VOD coil.
Kanger T3S,mini T3S and MT3S use the same bottom coil.

Factory page Electronic Cigarette,kanger,E-Cigarette,E-Cigs,quit smoking,Health Cigarette
Wholesale page KangerTech

The coils I have are for T3S and evod specifically, although I have been able to switch both to the other.
I've not had a factory coil vary more than .2 ohms.

 

[seeber]

Found these in stock: http://www.texasselectvapor.com/kanger-protank-replacement-coil-1-5-5-pack/

I'm sure you can expect the 1.5 ohm to be a little off as well. 1.4-1.6 probably, based on my experience with their 2.2 and 2.5 heads. Never used a 1.5 though.

 

[dodari]

Found these in stock: http://www.texasselectvapor.com/kanger-protank-replacement-coil-1-5-5-pack/

I'm sure you can expect the 1.5 ohm to be a little off as well. 1.4-1.6 probably, based on my experience with their 2.2 and 2.5 heads. Never used a 1.5 though.

Ah, thank you, that's what I wanted. Availability and price.

Thanks.