Kanger OCC Ni200 Coil Questions

[xdarktime]

Anyone receive the new Kanger OCC Ni200 coils for use on DNA 40 devices? The package states the resting resistance at 0.15, but whenever I insert the coils into my device, my VS DNA 40 (which hasn't given me any problems historically) reads the coil at around 0.20. Do you think this is just the margin of error for mass produced coils or is there something else wrong? Any opinions guys?? Either way, I'm getting a killer vape ... just want to make sure I'm within certain temperature parameters for health reasons. I have noticed that the DNA 40 does seem to fine tune the resistance read over time, so I'm wondering if it will work its way towards 0.15 eventually.

 

[fredrikstad]

Anyone receive the new Kanger OCC Ni200 coils for use on DNA 40 devices? The package states the resting resistance at 0.15, but whenever I insert the coils into my device, my VS DNA 40 (which hasn't given me any problems historically) reads the coil at around 0.20. Do you think this is just the margin of error for mass produced coils or is there something else wrong? Any opinions guys?? Either way, I'm getting a killer vape ... just want to make sure I'm within certain temperature parameters for health reasons. I have noticed that the DNA 40 does seem to fine tune the resistance read over time, so I'm wondering if it will work its way towards 0.15 eventually.

I waiting for a dna 40 Device. Anyone know if those coil heads are availeble somwhere in Europe? Ihave found them for Nautilus, but I would need for the Kanger SUB tank.

 

[retird]

First coil I used was 0.15 and refined down to 0.14.... second coil came in at 0.18 and refined down to 0.16....

 

[DreamWithin]

Moved from carto tank forum to Clearomizers

 

[WickedBad]

Check around the forums there seems to be a connection issue with these. I have mine set to 450 and it hits tc almost immediately even at low wattage.