Kanger Protank 2 Extra plastic rings in package?

[jayquik03]

Can anyone explain to me where these go? Are they supposed to replace other rings inside the kanger protank 2 or are they to be put on when you buy it? They don't seem the same size as the ones inside the protank 2 so i'm a little confused. Thanks.

 

[Rosenec]

I believe it's an extra o-ring for the drip tip

 

[tmrr]

They are generic, for a drip tip or to replace the rings that keep the tank snug to bottom and top pieces. They are not the same size. They do work though, just a bit of a pain. If you need to use them, press one half down into the slot and run a fingernail around the other half until it pops in. Because they are smaller, the side you have in will pop right back out if you don't hold it down.

 

[jayquik03]

lol thank you both. I knew it would be something obvious that I should have known. Should have asked a week ago

 

[izaidi]

I don't think they are generic. Those O-Rings sit between the gun metal base and the bottom metal casing for the glass tube.

They are not thick enough to be used for the drip tip. And they are not large enough to be used between the metal casing and and glass tube.

 

[GeorgeWachsmuth]

I don't think they are generic. I think their sole use it to be used to be sat between the gun metal base and the bottom metal casing for the glass tube.

They are not thick enough to be used for the drip tip. And they are not large enough to be comfortably used between the metal casing and and glass tube.

Yes...hold on to them.