Kanger subox mini 1.5ohm coil

[Steepage]

So my kanger subox mini has a 1.5ohm coil in it, but it reads on the display 1.6 (but ive seen it go as high as 2.1ohms while im vaping, I have to unscrew It an screw it back on till its back to 1.6) should I be worried?

Sent from my SAMSUNG-SGH-I437P using Tapatalk

 

[dhood]

If the resistance only jumps up to 1.6, not really a problem. If it jumps to 2.1, that could be. chances are your coil is a bit loose. Having the mod deliver power to a 1.6 ohm coil is different than having it deliver to a 2.1 ohm coil and it will burn the cotton if the power is up too high.

 

[Steepage]

If the resistance only jumps up to 1.6, not really a problem. If it jumps to 2.1, that could be. chances are your coil is a bit loose. Having the mod deliver power to a 1.6 ohm coil is different than having it deliver to a 2.1 ohm coil and it will burn the cotton if the power is up too high.

Thanks, ill just have to keep an eye on it. Im going to tighten the coil to the base if its loose.

Edit: the coil wasnt lose at all, but i unscrewed it from the base and put it in snug an good, but now It seems fine. Thanks.

Sent from my SAMSUNG-SGH-I437P using Tapatalk

 

[mamabear15]

Juice leaking into the connections can sometimes do that too (the bottom of the coil touching the inside of the deck, the outside bottom touching the mod itself...) Hit em with a q-tip or a rolled up piece of toilet paper (preferably clean TP, just sayin', lmao) and see if that helps?

 

[roisterboy]

My evic vt does this sometimes. It's never caused any problems for me.


Sent from my iPhone using Tapatalk

 

[Canadian_Vaper]

Unscrew the tank from the mod, at the bottom of the tank in the center of the 510 connector pull out the center pin(just the metal not the insulator).

Clean off the pin and the insulator as best as you can. Put the pin back in and see if it helped.

DO NOT REMOVE THE CENTER PIN FROM YOUR MOD but clean it with a qtip or something.

 

[Steepage]

Unscrew the tank from the mod, at the bottom of the tank in the center of the 510 connector pull out the center pin(just the metal not the insulator).

Clean off the pin and the insulator as best as you can. Put the pin back in and see if it helped.

DO NOT REMOVE THE CENTER PIN FROM YOUR MOD but clean it with a qtip or something.

Thanks, but I fixed it by replacing coils. It would say 1.5 for awhile then go back to 1.6, 1.7, all the way to 2.1 I got too scared of it being like a hazard (idk if it could blow up or not for having a misread) so I bought a new one but .5 this time because I like it better. But ill try it if I get issues again.

Sent from my SAMSUNG-SGH-I437P using Tapatalk