Kanger T3 replacement grommets

[vernhall]

Does anyone know of a source for the little rubber grommets that are used on the bottom of the T3 to separate the +/- wires from the housing? Mine are getting kind of (OK, a whole lot) tattered and torn from all my attempts to rebuild them...

 

[spider362]

Check out this thread : Possible Kanger T3 Positive Post Insulators

Haven't gotten an answer or had a chance to get them, though.

I don't know what he would charge for shipping for such a small order and I've been tempted to ask him if I sent him a couple dollars and a self addressed and stamped envelope if he would send me a couple to try on my T3.

 

[vernhall]

The review posted below it says it works on T3s so I'm going to go for it and order a couple packs out of desperation... I started paying very close attention to the grommets on the ones I've been attempting to rebuild and most of them have breaks/cracks on the side that may be what's leading to the short problems I've been having on the rebuilds... Will let you know for sure if they fit and what the shipping charge is once I get them... And, thanks for posting the link!!

 

[spider362]

Please do post back the shipping cost.

I would like to get a couple of packs, but if shipping exceeds the cost of the product, and there's nothing else I need, I'll have to pass.

 

[lynch]

Check out this thread : Possible Kanger T3 Positive Post Insulators

Haven't gotten an answer or had a chance to get them, though.

I don't know what he would charge for shipping for such a small order and I've been tempted to ask him if I sent him a couple dollars and a self addressed and stamped envelope if he would send me a couple to try on my T3.

You can estimate shipping cost if you put item in your cart then view cart and click the estimate shipping.
A small order to me in Va. is $2.07

 

[spider362]

That doesn't sound too bad for a couple of packs. Somewhere around $6 total including shipping.

 

[vernhall]

They work like a charm as far as 'fit' goes... Still no 'love' for me on the working part though -- still getting a short on almost every one I try to rebuild! Have no idea what I'm doing wrong -- have watched so many vids on how to do it my eyes are about ready to fall out! Am following the instructions to the 't', but still keep getting shorts... Has to be something in the very last stage (getting the grommet and pin placed) that's causing the probs, but what? And how to fix it? Oh well, today's another day -- maybe I'll get a chance to try again before the day's out...

 

[Vault]

I could do with some of these as a standy-by but I`ve read the small print and they say "we do not do international shipping" and I`m in the UK! :-( bugger!
I don`t suppose some kind vaper in the US could order an extra pack and I could arrange to pay for them (via Paypal perhaps?) and the little Airmail postage to send them over UK?
It`s not urgent but I thought I`d mention it for when someone puts an order in